adventure ® 05-Jun-2020 05:35
Illuminate how to obtain the cylinder liner wear rate of a 2stroke main engin.
Or offer a ebook about thi.
Thank you very muc.
0
Reply
smart74 14-Jun-2021 11:49
Man B&W 0.4-0.8% FROM NOMINAL DIAMETR DEPEND ON CYLINDER CONDITION.
IF YOU LINER DIAMTER 500MM MAXIMUM WEAR IS 500*0.4%=502MM, OR 500*0.8%=504MM
IMPORTANT IF PISTON WITH CROWN AND PISTON RINGS ARE NEW, PERFORMANCE STILL GOOD WITH WEAR 503MM, NOT NESESSARY TO REPLACE LINER, BUT OFFICE AND C/E DECIDE THIS.
0
Reply
Heads necessary to send messages to enable JavaScript

Similar topics

Inspection pcedure for piston, cylinder, liner, camshaft and two-stroke engine bearings. - MAN…
Guide for judging condition of relevant piston-running components (liners, pistons and piston…
Marine engine lubrication after 2020 white paper - Alfa Laval [2018, PDF]
Marine Medium Speed Diesel Engines - S. H. HENSHALL [1973, PDF]
MAN Diesel Service Letters - MAN B&W [200x, PDF]
B&W E-Series Operating Manual [2003, PPT]
Modern Marine Internal Combustion Engines: A Technical and Historical Overview - Levgen Bilousov ,…
MAN B&W Low Speed Small Bore Engines Now with Electronic Control - MAN [2014, PDF]
Wartsila ZAV40S Marine Engine - Wartsila [200?, PDF]
A Master's Guide to Using Fuel Oil Onboard Ships - Mark C. Ford [2012, PDF]
  • Reply

The time now is: Today 02:27

All times are GMT + 3 Hours