Because if you stop the compressor direct without keep it in low pressure stop the freon will keep high and it may increase due to any liquid back in the return line also and after a while it will convert to vapor which will lead to increase the pressure in suction line and when you try to start the compressor the pressure will be high on the piston and will lead to increase the consumed ampere and it may trip as well.
There are Couple of reasons for sucking/ collecting the ref gas in condenser before stopping the ref. compressor they are as follows 1. as the environment temp increases the ref pressure will increase any ref gas /liquid in the system will expand which can cause a rupture / unwanted leakages in the system. 2. AS correctly said in the above for maintenance purposes.
maybe you mean pump down? pump down is important when you decide to not use your system for a long time. when compressor stop for long time the refrigerant inside the evaporator might become liquid form and it's bad for your compressor to suck a liquid at large volume rather than gas, another reason is oil from compressor isn't 100% separated in oil separator. therefore there is oil inside your evaporator. when you stopped your compressor for a long time the oil and the liquid refrigerant will mixed together and return into comp crankcase when you run your system which isn't good for your comp lubrication. there is more reasons to pumping down your system.
any time. operator of ref plant must read instruction manual. if ref plant compressor stopped by operator - usually way collect all freon in liquid receiver and condenser. it is safety matter for equipment and crew.
Вы можете начинать темы Вы можете отвечать на сообщения Вы не можете редактировать свои сообщения Вы не можете удалять свои сообщения Вы не можете голосовать в опросах Вы можете прикреплять файлы к сообщениям Вы можете скачивать файлы
admin
1. as the environment temp increases the ref pressure will increase any ref gas /liquid in the system will expand which can cause a rupture / unwanted leakages in the system.
2. AS correctly said in the above for maintenance purposes.
when compressor stop for long time the refrigerant inside the evaporator might become liquid form and it's bad for your compressor to suck a liquid at large volume rather than gas, another reason is oil from compressor isn't 100% separated in oil separator. therefore there is oil inside your evaporator. when you stopped your compressor for a long time the oil and the liquid refrigerant will mixed together and return into comp crankcase when you run your system which isn't good for your comp lubrication. there is more reasons to pumping down your system.